ATTO Technology UL2D Especificaciones descargar pdf (Pagina 88)

6-8

Changing System BIOS and Creating Windows NT Image

Restoring the Original Boot Sequence

You must now restore the original boot sequence so you don’t attempt

to boot from a CD-ROM that you accidentally left in the system. This is

not critical, but should be done to bring the state of the system back to

normal.

To restore the original boot sequence:

1. Press Ctrl+Alt+Delete, click Shut Down, and then select the

Shutdown option (not the Shutdown and Restart option).

Turn off the system and leave it off for at least 5 seconds.

When you press the Power button to turn off the system, it takes 4 or

5 seconds to actually turn off. Do NOT press the button again to try

and turn off the system or the system will turn back on.

2. Turn on the system using the Power button and press F1 when

asked for at the IBM logo.

You are placed into the system BIOS at the Configuration/Setup

menu (Main menu) after the execution of the SCSI BIOS.

3. Press the Down Arrow key to reach the Start Options menu

selection and press Enter.

The Start Options menu appears.

4. You are automatically placed at the Startup Sequence selection.

Press Enter.

5. Press the arrow keys to select the following startup devices under

the Primary Startup Sequence section:

- First startup — Diskette (floppy) drive 0

- Second startup — Hard disk 0

- Third startup — CD-ROM

6. Press the Esc key to return to the Main menu.

7. Press the Down Arrow key to reach Exit Setup and press Enter.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 117 118

Sin comentarios

ATTO Technology UL2D Especificaciones Pagina 88