ATTO Technology UL2D Especificaciones descargar pdf (Pagina 86)

6-6

Changing System BIOS and Creating Windows NT Image

You will be warned two times during the following procedure that

you are about to destroy data on all, or parts, of hard drive 0.

To perform a complete recovery (image the complete disk):

1. Press the arrow keys to highlight choice 1 (full recovery) and press

Enter.

You will be asked if you really want to continue, because this

destroys data on hard drive 0.

2. Answer by pressing the Y key. Do not press Enter.

You will be asked again if you really want to continue, because

this destroys data on hard drive 0.

3. Answer by pressing the Y key again. Do not press Enter.

At this time the program will take about 5 minutes to place the

Windows NT image on hard drive 0.

To image the disk, the program fools the system into thinking the CD-ROM is

drive A (floppy drive). Do not let this bother you during the installation.

The image takes about 5 or 6 minutes to install. You will see a

“Setup Complete” message once the image has been completely

written.

4. Remove the CD-ROM from the CD-ROM drive.

5. Press Ctrl+Alt+Delete. This continues the boot sequence.

6. Select the Windows NT 4.0 option during the boot sequence.

7. Press the arrow keys to select Original Configuration and press

Enter.

The system continues to boot for the first time since you created

the image. You will be asked questions relative to the software

licensing of the Windows NT operating system.

8. The Welcome to the Setup Wizard window opens. Click Next.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 117 118

Sin comentarios

ATTO Technology UL2D Especificaciones Pagina 86