ATTO Technology UL2D Especificaciones descargar pdf (Pagina 68)

4-18

Installing Memory, the Avid Board Set, and the Fan Kit

Installing the Genie Effects Board

The Genie effects board is available equipment on Avid Composer

products systems and specific versions of Avid Xpress systems.

Interconnection between the Genie effects board and the Meridien III

digital media daughter board is accomplished with a newly designed

flexible over-the-top connector.

1. Ensure that the Meridien III digital media board set has been

assembled and installed in the system in the same way as the

Meridien III-U digital media board set (see Figure 4-4).

2. Install and secure the Genie effects board into the PCI slot

recommended in the product board configuration tables.

3. Orient the flexible over-the-top connector in the same way as was

done for the Mercedes effects board (see Figure 4-7), and then

carefully seat the flexible over-the-top connector into the daughter

board and Genie connectors.

The device driver is installed when the Avid editing product is

installed.

Removing the Flexible Over-the-Top Connector

Although the flexible over-the-top connector has tabs, you should not

use the tabs alone to remove it from the digital media board set. Using

your thumb and forefinger on both hands placed at the locations

shown in Figure 4-8, gently pull the flexible over-the-top connector

from the Mercedes or Genie effects board, and then from the Meridien

digital media board set.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 117 118

Sin comentarios

ATTO Technology UL2D Especificaciones Pagina 68