Atto-technology 2400C/R/D Manual de usuario descargar pdf (Pagina 28)

ATTO Technology Inc. FibreBridge Installation and Operation Manual

4.0 Modify System Values

To configure the ATTO FibreBridge, use ATTO ExpressNAV. Default values are appropriate for most

configurations, but may be modified.

The best way to access the FibreBridge to view and

change settings is to use ATTO ExpressNAV, a

browser-based graphical interface. Other methods are

also available. Refer to Interface options

on page 27.

Help is available from within ExpressNAV for any

headings displayed in red. For more information on

any of these parameters, refer to the specific CLI

command in Command explanations

on page vi of the

Appendix.

You may make changes to several pages before going

to the

Restart

page and restarting the FibreBridge to

save the changes.

Preliminary steps

1 If you are not already in

the ExpressNAV

interface, type the IP

address of your

FibreBridge in a

standard browser as

found in

Using

ExpressNAV

on page

27, click

Enter Here,

type in your user name

and password, and click

OK.

2The

Status page

appears. Choose the

page you need.

Modify passwords

1 Follow the Preliminary steps.

2 From the side menu select

Bridge.

The

Bridge Configuration page is displayed.

The Administrator user name that you are

currently logged in with and the current read

only user name, if present, are displayed in

their text boxes.

3 Enter the Administrator (

Admin) password

where indicated.

4 Enter appropriate information into the

New

Admin Password, Confirm New Admin

Password or New Read Only Password and

Confirm New Read Only Password

text

boxes.

5 Click

Submit.

6 If you have completed all changes for this

session, go to the

Restart page and restart the

FibreBridge.

Enhance performance

SpeedWrite is a method to improve the performance

of WRITE commands to SCSI tape devices attached

to the FibreBridge.

Using the CLI command

SpeedWrite

, you can

specify the SCSI bus, target and LUN of a mapped

device or specify [all] to set or get the state of all

currently mapped SCSI devices.

SpeedWriteDefault

specifies the state of

SpeedWrite

for any SCSI devices mapped manually

or via an

AutoMap

operation. If enabled, any new

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Comentarios a estos manuales

Sin comentarios

Atto-technology 2400C/R/D Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Atto-technology 2400C/R/D