ATTO Technology FC-3321 Guia de preparacion descargar pdf (Pagina 5)

Removing the ATTO ExpressPCI-FC 3300 or 3320

13. Right-click the ATTO ExpressPCI-FC 3300 or 3320 Fibre Channel

Adapter, and select Uninstall. The Confirm Device Removal dialog

box opens.

14. Click OK.

15. Repeat steps 13 and 14 for each ATTO Phantom Device.

16. Close the Computer Management window.

17. Shut down the LANserver EX system.

Removing the ATTO ExpressPCI-FC 3300 or 3320

Adapter Boards

If your LANserver EX system has one or more ATTO ExpressPCI-FC

3300 or 3320 adapter boards installed, you must remove all of these

adapter boards from the LANserver EX system before installing the ATTO

ExpressPCI-FC 3321 adapter boards.

To remove the ATTO ExpressPCI-FC 3300 or 3320 adapter boards:

1. Shut down the LANserver EX system.

2. Open the LANserver EX front door.

3. Loosen the cover hold-down screws.

Some LANserver EX systems have a single screw at the top center of the

front panel. Other LANserver EX systems have two screws at the top center

of the front and back panels.

4. Slide the cover back approximately 1-1/2 inches.

5. Lift the cover off of the enclosure.

6. Remove the board retainer bar screw on the right side near the back of

the enclosure.

7. Lift the right side of the board retainer bar up and pivot the bar to the

left. The board retainer bar must be almost vertical on the left side of

the enclosure to remove it.

8. Lift the board retainer bar out of the enclosure.

0575101A_IN.fm Page 5 Thursday, March 13, 2003 4:13 PM

1 2 3 4 5 6 7 8 9 10 ... 13 14

Sin comentarios

ATTO Technology FC-3321 Guia de preparacion Pagina 5