ATTO Technology 2400C/R/D Especificaciones Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 77
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
7
ATTO Technology Inc. iPBridge Installation and Operation Manual
GbE cables must be at least CAT-5E certified for
1000 Mb/sec. use.
Serial interface
The RS-232 serial port provides support for
remote monitoring and management through a
command line interface. It is set at the factory at
115,200 bps.
Pin outs of the RJ11 connector, part number CBL-
0911-001 are
Installation instructions
1 Install the iPBridge 2500C in the target device.
(See the board layout diagram below)
2 Connect SCSI devices to the iPBridge. and
attach CAT 6 or CAT 5E cables to the GbE data
port(s) on the iPBridge. (For details, refer to the
Appendix, Cabling, on page iii).
3 Connect to power.
4 Configure the iPBridge using the instructions in
Configuring the iPBridge
on page 9.
Exhibit 1.2-1 ATTO iPBridge 2500C faceplate
Pin Description
2TXD
3 Ground
4RXD
5 Ground
SCSI ports
Ethernet data ports RS-232 port
Ethernet
management
port
Fault LED
SCSI LEDs
Ethernet port link and activity LEDs
SCSI Port 0
SCSI Port 1
Fault
Management Port
RS-232
Data Port 0 Data Port 1
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 76 77

Comentarios a estos manuales

Sin comentarios