ATTO Technology 2390 Guia de preparacion Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
3 If you are using more than one panel, use network cables to connect each of the panels to the network
switch.
4 If you are using the panel that includes the tablet, use a USB cable to connect the panel to a USB port
on the back of your workstation.
Configuring the Autodesk Control Surface
Assigning an IP Address to the Autodesk Control Surface
After you have connected the Autodesk Control Surface, you must assign it an IP address.
To configure the IP address on workstations:
1 Click Start | Settings | Network Connections.
NOTE You can also access Network Connections from the Control Panel.
2 Right-click the port that the Control Surface switch or panel is connected to and choose Properties.
20 | Chapter 3 Connecting Peripherals
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Comentarios a estos manuales

Sin comentarios